Double sided tape / Adhesive tape
- High-strength Tissue Tape
- Electronic Die-cutting Adhesive Tape
- Ultra-thin High Adhesion Adhesive Tape
- PET Adhesive Tape
- Non Carrier Transfer Tape
- PE/EVA Foam Adhesive Tape PE/EVA
- Flame Retardant Tissue Tape
- Economical Solvent Acrylic Adhesive Tape
- Economical Water-based Acrylic Adhesive Tape
- Economical Hot-melt Acrylic Adhesive Tape
Double-sided tape needs to pay attention to the significance of fire prevention
1. The warehouse where the double-sided tape is stored should be ventilated. When the volatilized glue mist of the tape reaches a certain proportion of air, it will burn violently when it encounters a fire. Use steps and common corpus analysis!
2. The warehouse should be equipped with standard fire-fighting equipment to extinguish fires in time. Ensure that the fire hose is not more than 50 meters away from the tape storage location and is long enough to ensure that the fire hydrant has sufficient water pressure and water volume.
3. It is forbidden to stack sealing tape at the safety exit. The warehouse should be stacked neatly, and each row should have enough space to prevent water collision in the event of a fire, instead of burning inside. Unable to control the fire. In addition, please be careful to place the tape in a place without moisture and ventilation to ensure the performance of the tape.
4. No smoking and other disasters. It is recommended to post posters with signs of prohibition, prohibition, etc. If necessary, write the terms in the employee handbook.
5. When using an automatic tape sealing machine, the speed of the tape sealing machine should be adjusted to avoid rapid friction causing a fire.
6. The belt joints are treated with heat vulcanization to improve reliability and maintain high effective strength.
7. The single diameter of the conveyor roller and the diameter of the small pulley of the conveyor belt should meet the relevant regulations.
8. Don't make the tape snake or squirm, keep the roller, the vertical roller flexible, and the tension should be moderate.
9. When a baffle and cleaning device are installed on the conveyor belt, please avoid tape abrasion.
10. Cleanliness is the basic condition for good tape handling. The foreign matter will affect the eccentricity of the belt, poor tension, and even damage.
11. When the tape is damaged early in the use process. The cause should be discovered and repaired in time to avoid adverse consequences.
When the double-sided tape is slit, if the slitting knife is not adjusted properly or the blade is not sharp enough, cracks will appear on the surface or bottom paper of the double-sided tape, and the fibers pulled out of the crack will be adhesive. stick to. The onset of cracks may be consecutive or random and may appear on one side of the roll of double-sided tape, or on both sides. Therefore, before machining on the double-sided tape, carefully observe the bottom paper and face paper. Whether there are small cracks on the surface.